ShIP to

diy portable led panel

by:Dolight LED Panel     2019-09-03
In this project I will show you how to create a powerful and powerful 70W LED panel that can be made by Li-Ion or Li-Po battery pack.
The control circuit can separately dim the pure white and warm white 5630 LED light strips and will not cause any flashing problems due to the fast pulse frequency.
Let\'s start!
These two videos give you a basic idea of how to create a portable LED panel.
In the next steps though, I will give you more information to make it easier for this project to be recreated.
The first video is about the mechanical structure of the LED panel.
You can recreate my design as per the guidelines and measurements mentioned in the video.
Feel free to also use the reference image that comes with my panel.
The following materials are required to complete mechanical manufacturing: Ebay: 10m 5630 LED light strip (Germany)
: 5630 LED light bars (Worldwide)
: Aluminum plate (Germany)
Aluminum flat bar (Germany)
: 5 m 5630 LED strip warm White: 5630 LED strip pure white: Shop: screws and nuts (
As shown in the video)
, Acrylic glass, aluminum plate, aluminum flat bar, handle. Here you can find a list of parts that list the sample sellers of the components needed for the dimmer circuit.
Ebay: 1x Buck/boost converter: XT60 connector: balance connector: TLC555: TC4420 MOSFET driver IC 1N4148 diode: 50k Ω potentiometer: 10 Ω, 2x470 Ω resistor: DPDT switch: liPo voltage tester: Buck/boost converter: 1x XT60 balance connector: TLC555: 2x TC4420 MOSFET driver IC: IRLZ44N MOSFET: PCB terminal: DC Jack: 47 f capacitor: 100nF, 2x 1nF capacitance: 1 DPDT switch: LiPo voltage tester: Step down/boost converter: 1x XT60 connector: balance connector: TLC555: 2x TC4420 MOSFET driver IC: IRLZ44N MOSFET: PCB terminal: DC Jack: 47 f capacitor: 100nF, 2x 1nF capacitor: 1N4148 diode: 50k liP O Voltage tester: you can find the schematic diagram of the control circuit and the reference picture of my circuit.
Here you can download my housing design 12 3d design.
Import it with software and export it as an STL file in order to slice with your favorite 3D printing software. You did it!
You just created your own portable LED panel!
Custom message
Contact